x Want to participate? Join the group to interact
  • Replies 27 replies
  • Subscribers 117 subscribers
  • Views 28584 views
  • Users 0 members are here
Browse Forums
Announcements
268
topics
260
replies
Databases and Operating Systems
758
topics
2k
replies
Financials Suite
1k
topics
3k
replies
General Discussion
2k
topics
10k
replies
Operational Suite
851
topics
2k
replies
Reporting and Analytics
1k
topics
3k
replies
Reports, Macros, and Customizations
876
topics
3k
replies
Sage CRM for Sage 300
182
topics
410
replies
andybruner1

SAGE 300 ERP 2012 problem with custom crystal reports - Missing parameterfield current value

Posted By

I am testing SAGE 300 ERP 2012 and have come across a problem with a number of custom crystal reports that I have designed.   The reports run just fine in ACCPAC 6 and in crystal designer but when I run them from within ERP 2012 a message will pop up that says "Missing parameterfield current value".    Some reports will run fine but there are quite a few that won't and there doesn't seem to be anything obvious that these reports have in common.  Anyone have any ideas?  

Parents

  • I tried that on my end but no luck. :-(  I totally deleted the SORTORDER param and added it back but it still won't sort by Cost Center.   

    So when your first tried it it wouldn't sort by Cost Center either?  But then after redoing the parameter it did? 

  • in reply to andybruner1

    I know this thread is from a long time ago but I came across this problem today and it was weird because I had a batchto and a batchfrom parameter and selection on the report and it just wouldn't accept batch 3, out of all the batches, just when run from the desktop and I was slowly losing my mind and then I realised that the report was set to "Save data with report", when I took that setting off, it worked.

    That may help someone in future.

Reply
  • in reply to andybruner1

    I know this thread is from a long time ago but I came across this problem today and it was weird because I had a batchto and a batchfrom parameter and selection on the report and it just wouldn't accept batch 3, out of all the batches, just when run from the desktop and I was slowly losing my mind and then I realised that the report was set to "Save data with report", when I took that setting off, it worked.

    That may help someone in future.

Children

*Community Hub is the new name for Sage City