"Updating Job Cost Phase" Database From Estimate

Question

I have updated few "JC phase" items in the estimate and then tried to update these item in "DATA Base" with utilizing 
 " 
 I have gone through all steps from inserting "Update DB" col and check make the items and also followed all steps after.

But, after all passing commands, Sage can't updated as planned and get the message "No Differences" 
 I am sure the items are not same as in the database. 
 
 is there anyone has the same issue/experience ? (if) Where I gone wrong? I am using Sage 20.1.2010.063 ver

ROBERT WELLS · Accepted Answer

Hamid- we don't use that feature so I don't know of any issue, but from the screen clip, I see that you have the Job Cost Phase checked, but I also note that that is the Labor Job Cost Phase. I suppose you know there are four other ones for all LMSEO cost types, so it doesn't hurt to ask... checked those too?

Hamidk · Answer

Hi Robert! 
 Thanks again for looking my question... much appreciate it 
 I have tried and checked all LMSEO, those at the same time as well but didn't work. I must double check and see all LMSEO are enabled for that particular item in database or not.

Hamidk · Answer

Robert .. 
 Good news, It worked! 
 I made a specific tab for the "cost phase" and did the same procedure and solution that mentioned. 
 It is working! 
 Thanks

Sage Construction & Real Estate

"Updating Job Cost Phase" Database From Estimate

Top Replies

COMMUNITY

COMPANY

PARTNERS

SUPPORT & TRAINING