Hi jpgvmms,

You can check the warings in Administration > Utilities > Update and click on the details of the P26.

There if you click on X3 folder, you will see all the folders that the patch have been installed and the status.

If you have a warning status on a folder, you can click it and read the log.

Those logs are located on the TRA folder of X3 in the application server.

Once located or oppened from update menu, read them carefully and analize the warning(s) in order to correct them or assume that there is no problem for your installation.

Regards.

Jose H.

Thank you.

I dont understand. I was on P25 and applied the patch 26 but this is so confusing, look: On Apply to folders there is a status not updated both the reference folder and the seed folder have the same status. The detail status shows: No Patch found that can be applied.

Then under that box, there is another one, Result: Applied, with a green checkmark, Detailed status
(Test)The update finished with warnings. There is not log for the warnings.

Hi @jpgvmms,

When you apply a patch you only have to add the reference folder because the patch will be applied to that folder and all son folders.

Can you upload a picture with the "apply to folders" that you have?

Also have a look to Administration > Utilities > About. Click on the folders and have a look to the version.

Its possible that you have done the test of the patch installation?

Regards.

I did not use the test function. Here is the screenshot I hope you can see it.

Hi, I think that you have that message because your folders are already in P26.

Check Administration > Utilities > About and click on the folders to see in which patch are.

If P26 is the patch, is normal that when you try to update to the same patch you have the message "no patch found that can be applied".

Regards.