• Fringe benefits and before tax IRA

    I have a payroll question related to fringes and employee IRA contributions. This is a simple IRA and is taken before taxes. I have the fringes set up as a benefit on the appropriate paygroups with an offset for each employee based on the benefits we…
  • Wokers' Compensation Calculations

    Does anyone happen to know the 'behind the scenes' math for the 5-3-2 Workers' Compensation table window? I need to know how to set it up for the most accurate job/employee costing. For example does the Liability column calculation run after the Employer…
  • PTO Accrual: Limits and carryover

    Good Morning, I am new to the Sage Community about 4 months. I am evaluating the leave balances and accruals for all of our employees and I am having some concerns as to the set up. We have employees that earn 40 hours a year (new Hires) then after…
  • Federal Income Tax allowance

    On the Calculations tab for an Employee (5-2-1) how do I specify that the Federal allowances specified on the employee's W-4 is "married but withhold at higher single rate"?
  • Subtotals in AP (Select Invoices to Pay)

    When I go in AP to set invoices up for payment ... AP - Tasks - Select Invoices to Pay - On Screen List. Is there a way to show subtotals for each of the vendors / suppliers I am paying? I do see that I can go in and view the total (by going into…
  • State Withholding

    What have other companies done to setup reciprocal state withholding? This becomes an issue only when the primary state withholding is higher than the withholding in the state for the construction project. Connecticut is our primary (HQ) state. …
  • Is it possible to alter labor hours using a calculation without changing the takeoff unit to hours in Estimating Extended?

    I want to add a calculation in my assembly that will change the labor hours behind the scenes. My takeoff unit is EA and I don't want to change that. For example: If I have a qty of 10, I want my labor hours to be unaffected. If I have a qty of…
  • How do I make a new payroll formula based on a percentage of gross pay?

    I need to first compare 15% of Gross Pay to a flat amount of $114.75. If 15% of Gross Pay is greater than $114.75, then use $114.75. If 15% of Gross Pay is less than or equal to $114.75, then use 15% of Gross Pay. Here is the formula I have so far that…
  • Subcontractor Application for Payment

    I am a Commercial General Contractor. I am new to Sage and am quite surprised to see Sage 100 doesn't have a stock Subcontractor Payment Application form. Typically, I have used these Forms to recap a Subs Progress in order to issue payment. We issue…