In WO, Setup, Work Center Maintenance, there is a checkbox to designate a Work Center as Outside Processing.  Then you create an Operation Code using that Outside Processing Work Center and add it to a Routing or directly on the Operations tab in WO Entry.  The Outside Processing Planned Cost is created based on Outside Processing Work Center designation and the labor rate set in the Operation Code that uses that Outside Processing Work Center.

Thank you for your response. I followed the steps and it is what we have been attempting but it still does not show the Standard Cost for the Outside Process on the Work Order Inquiry. Any other ideas? 

Check the Operation Code to confirm there is a labor rate entered.  Check the Operations tab to make sure hours were entered for the Outside Processing Operation Code.

So that got it to where it shows up under the Standard Cost for the Outside Process on the Work Order Inquiry! Thank you! We send parts out for Heat Treating and different parts cost different amounts, will we have to enter different Rates in the Operation Code to account for the various prices we pay out so that it will set up the correct Standard Cost?

Yes, you could create unique Operation Codes to account for varying rates.  Set up one operation code for each rate.

Is there a way to have standard cost per piece. We pay a vendor by piece not by a rate. 

Yes.  You can select a Standard Labor Rate Per Piece in Work Order / Setup / Operation Code Maintenance.

I have tried to select  just the Rate/Piece under Work Order / Setup / Operation Code Maintenance / Standard Cost Rate / Planned Cost, but it won't show the Standard Cost on Work Order inquiry unless I put in something under the Rate/Hour. Don't know if there is a way you can do just Rate/Piece without having something in the Rate/Hour? If so I haven't figured it out yet.  

I suggest you create a support ticket with Sage for further troubleshooting of this issue.