Where are you pulling the GL Account # & Description Col's C & D?

I am getting it from the panel found on the left hand side of the report. i now realized taht i should be getting it from a GL container found in the connector, correct?

Yes. Go to the Accounts Sub Report. Report Designer Add-In - Accounts 1-0

Go to the reports Container.

Add an Expression.

Select Data Field

Select GL_Account

Select Status

Go back to the sub report Report Designer Add-In - Accounts 1-0

Go to the Columns tab and add Status to the end.

Run the Report.

Unhide the Accounts tab should look like the following:

On the tab you have the Trail Balance in the Status Column link it to the Accounts tab Status Col.

Thank should do it.

I added the field to the container but the part that gets me confuse is when you say to go back to the report designer accounts 1-0 a 2nd time to add the STATUS column. Is that in the report viewer? becuase when I do that the  status column has no info.

Ignore my earlier statement.

I added the field to the container. I generated the report and added the column "status" , close and save the template, and reran the report but nothing appeared in that column.

After you added the Status field to the Report Designer Add-In - Accounts 1-0 Container in the Connector did you add the field to the Sub Report Report Designer Add-In - Accounts 1-0 in the Report Manager?

Should look like this:

My Report designers add in look like this:

Is it because you created "standard reports"?

If you Right Click on the Home folder at the top and select Show Hidden Reports you will see the reports like the screenshot I sent.

Ahhhhh, got it. Thank you so much!!!

You are welcome.